Use this kit to install any 5 volt USB-c Dashcam into your vehicle (up to 3 amp).
If your Dashcam has ;parking mode, this hardwire kit will unlock the parking mode options.
 
It will monitor your vehicle battery and cut the power to the camera when the battery reaches the set low voltage.
 
Easy and fast installation 
Vehicle Battery protection for low voltage 
3 mtr cable with right angle USB-c connector
5 volt 3 amp supply
Comes with 2 prewired mini 10amp fuses (for connection into spare sockets or to replace your existing 10amp fuses)
Installation instruction guide
 
The hardwire kit will switch the dashcam off at 11.8v and is great for daily driving use and low battery protection. You would also normally have parking mode settings within your dashcam menu but this would vary depending on manufacturer.
 
** Please note that the Standard Kit comes with 2 x prewired fusetaps with Mini fuses. You can plug these into spare slots or find a relevant 10amp fuse in your vehicle. It is important to note the correct orrientation of the fuse when you install, there is a photo showing this. If you have different fuse types then make your selection for seperate fuse taps to use in occupied fuse slots where you will recieve 2 Fusetaps of your choice. You can then cut off the prewired fuse(s) and use the seperate fusetaps. **
 
 
INSTALLATION INSTRUCTIONS:
Yellow Wire - connect to a permanent 12/24 volt feed
Red Wire - connect to a switched (ACC) 12/24 volt feed
Black Wire - connect to Ground
 
Compatible with All USBC dashcams, such as the RedTiger dash cam range.
 
 
SPECIFICATIONS:
 
Input
12V-24V
Output
5V/3A
Fuse Type:
Mini 10amp
Car Low Voltage Protection 
11.8V