OBD to Blackvue Dashcam
OBD Power pro X cable allows you to connect your Blackvue X series Dashcam directly to the vehicles OBD port to power the Dashcam and take advantage of Parking Mode with your Blackvue Dashcam.
The Power Pro monitors your vehicles voltage and should this drop below 12 volts the blackvue Dashcam will automatically power off.
OBD Power Pro X Cable Extra Info
• Length: 3.5m
• Easy installation, connects to vehicle’s OBD II port
• Parking and Standard modes
• Battery discharge protection
• Compatible with BlackVue DR590X, DR750X, DR770X and DR900X, DR970X models
PROGRAMMING THE CONNECTA OBD PLUG
1. Plug in the Connecta OBD power plug
2. If it does not power up the Camera turn the ignition on
3. Start the vehicle and run it for 10 seconds
4. The camera will now power up
5. Cycle the ignition and the camera should power up again
**The Connecta has just been programmed to monitor the voltages of the vehicle through the OBD***
Great for those that wish to fit their own Blackvue X model Dashcam and hide the wires in minutes.
No need to worry about hardwiring in to the fusebox, just DIY and plug straight in with this kit!
OBD to Blackvue Power Pro X Cable
- Easy installation, connects to vehicle’s OBD II port
- Cable length 3.5m
- Switchable Parking and Standard modes, Battery discharge protection at 12v cut off
- Compatible with BlackVue DR590X, DR750X and DR900X models
- Included Components: instruction card