top of page
Dashcam Hardwire Cable kit - Advanced Two camera supply system

Use this kit to install any Micro USB 5 volts Dashcam into you vehicle with both front and rear power leads.

It will monitor your vehicle battery and cut the power to the camera when the battery reaches the set voltage. You can also wire in the ACC lead to specify the time that parking mode is recording for.


  • Easy and fast installation 
  • Vehicle Battery protection for low voltage and timer function to prevent discharge (various selectable voltages)
  • 2 x supply leads for both front and rear camera:
  • 1 x 2mtr cable with right angle micro USB connector
  • 1 x 2mtr cable with female USB connector
  • 5 volt 2.5 amp (total) supply



Red Wire - connect to a permanent 12/24 volt feed

Yellow Wire - connect to a switched (ACC) 12/24 volt feed

Black Wire - connect to Ground


Dip Switches 1 to 4 are selected according to the Voltage Protection

Switches 5 to 8 are selected acording to the length of time for parking mode (it is suggested to enable 12 or 24hr for optimum performance)


We offer a fuse cable & fuse for wiring this into your vehicle.

Please note that only the RED 12v cable is recommended to have a fuse.



Model NoTABM-1
Fuse Type:63V/3A
Car Low Voltage Protection (selectable)

11.5V, 12V, 12.5V, 13V

Parking Model Timer Function12hr, 24hr, 48hr, infinite

Dashcam Hardwire Cable kit - Advanced Two camera supply system

Rating is 5.0 out of five stars based on 1 review
SKU: 0604565055934