Our very own designed from scratch, rear dashcam camera mount, professionally 3d printed in house in tough heat resistant ABS durable plastic.
 
If you are installing your own dashcam, you can use this custom created mount to avoid the tough tailgate install, that is particularly harder on Jaguar, Landrover vehicles, VW, BMW, Porsche etc. 
 
Instead of trying to route your rear dashcam cables through the tailgate grommet, use this unique camera mount by simply slotting it onto your trim headliner and then routing your cables along the trim and securing your camera to this mount.
 
Installing a rear dashcam on Jaguar/Landrover vehicles with tailgates requires you to remove 2 trim sections and 4 bolts to then gain access to the rubber grommet channel  under the spoiler, often adding on around 45 minutes to the install. On VW vehicles there is a special way to remove the grommet and 9 times out of 10 people end up breaking this if they dont know how to remove it correctly and the result is water in your boot when it rains!
This can also be daunting if youre not familiar on how to remove the tailgate and route the cable accordingly.
 
This bracket will allow a speedy and professional looking install even from a DIYer that wishes to install their own dashcams.
 
Available in 3 sizes (or a cost saving bundle of all 3!), all you need to do is measure the depth of your headliner trim.
 
Depending on your camera, you might have to wipe the mount face with nail polish remover. This will allow an ultra shiny surface for your dashcam to stick too.
 
In any case, please check the measurements that will be specific to your vehicle (we have started listing sizes and vehicles below based on feedback but please still check your own as there may still be variances).
 
Audi A3 : DC03
BMW 3 series tourer 2024 : DC03
BMW X5 2024 : DC03
Ford Focus 2023 :  DC02
Jaguar FPace 2024 : DC02
Jaguar iPace 2018 :  DC02
Nissan Juke : DC03
Renault Clio : DC03
Subaru Forester 2024 : DC02